Replacement of anti-roll bar bushing - TEDGUM

Replacement of anti-roll bar bushing

Below we present the instruction for replacing the anti-roll bar bushing:

A – Before disassembly:

1

wymiana gumy stabilizatora - przed demontażem — 1) Anti-roll bar
2) Bushing clamp
3) Anti-roll bar bushing

B – Disassembly:

1

obraz wymiana gumy stabilizatora 1 — Using a wrench, unscrew the bolts securing the rubber clamp

2

obraz wymiana gumy stabilizatora 2 — After unscrewing the fixing screws, remove the clamp

3

obraz wymiana gumy stabilizatora 3 — Remove the worn anti-roll bar bushing

C – Assembly:

1

1) Worn bushing
2) New bushing

If there is no cut on the anti-roll bar bushing, it should be made in the same place as in the original

2

Wymiana gumy stabilizatora -montaż krok 2 — 1) Grease point
2) New anti-roll bar bushing

Mount a new anti-roll bar bushing. If it is a polyurethane element, lubricate it with the included lubricant

3

obraz wymiana gumy stabilizatora 6

Put the clamp back in its place

4

obraz wymiana gumy stabilizatora 7

Use a wrench to tighten the bolts securing the clamp

5

obraz wymiana gumy stabilizatora 8

Correctly mounted element

Download the manual in a PDF

Manual shown above is just a presentation showing how the repair procedure can be made. TEDGUM® company does not bear responsibility for any errors in the manual and incorrect interpretation of the manual. Repair should be preceded by skilled personnel with the use of appropriate tools and with keeping all the safety means. All rights reserved.

More in this category

Replacement of metal-rubber-metal bushing with metal-polyurethane or metal-rubber non-glued manual(Manual #17)

2022-04-04

Some bushing can be available in construction composed of 2 elements. This solution is more popular for polyurethane bushings, but

Disassembly of the metal-rubber-metal bushing and assembly of the metal-polyurethane bushing (2 halves) without the outer sleeve (Manual No. 24)

2022-02-17

The following instructions show how to properly replace a metal-rubber-metal bushing with a metal-polyurethane bushing consisting of 2 halves and

Manual for the puller TED97715

2021-09-06

Bushings puller TED97715 for the bushing 00503549 in Opel Astra H and Opel Zafira B. The puller allows the correct

Removal of metal-rubber-metal bushing and installation of non-glued metal-PU or metal-rubber bushing (Manual No. 16)

2021-08-27

How to correctly replace 3-parts bushings? Before replacing Removal process 1 Remove the inner sleeve with the rubber, leaving the

Correct way to install metal-polyurethane bushings (with 2 flanges) (Manual No 15)

2021-07-30

Very often, in the case of polyurethane bushings, there are 2 polyurethane parts with flanges, inside which a metal sleeve needs to be pressed.