Replacing the SAAB 9-3 engine mount insert

In the guide below, we shows how you can easily replace the rubber insert in the engine mount on a Saab 9-3 car. Replacing whe whole engine mount can be expensive, however the solution that Tedgum proposes, significantly reduces the cost of repair.

Replacement process:

1

Mark the element for future cuts are to be made.

2

Element with notches made. Incisions can be made by any technique. It is important to cut only the folded collar.

3

Bend the notches around the entire circumference to be able to press out the cushion rubber element freely.

4

The next step is to pull the rubber element out of the housing. Press on the inner metal part of the insert.

5

The extruded damping element that has visible signs of wear and needs to be replaced.

6

Set up the new element correctly, remembering to correctly position the inner insert relative to the socket.

7

Before pressing on the press, the element should be lubricated thoroughly to reduce friction.

8

Use a press to press in the new insert.

9

Correctly pressed in element.

10

We fasten the element rigidly (e.g. in a vice) and precisely bend the collar.

11

A properly repaired element should look like above.

Manual shown above is just a presentation showing how the repair procedure can be made. TEDGUM® company does not bear responsibility for any errors in the manual and incorrect interpretation of the manual. Repair should be proceded by skilled personel with the use of appriopriate tools and with keeping all the safety means. All rights reserved.

Share on facebook
Share on twitter
Share on linkedin
Share on email
Share on print

More in this category

Do you want to be informed? Subscribe to our newsletter !