Disassembly of the metal-rubber-metal bushing and assembly of the metal-polyurethane bushing (2 halves) without the outer sleeve (Manual #24)
The following instructions show how to properly replace a metal-rubber-metal bushing with a metal-polyurethane bushing consisting of 2 halves and
New products – January 2022
We welcomed the new year with another set of new products, including 3 polyurethane sets: one for BMW cars and
TecDoc Premier Data Supplier
Precise information about the application of our products is very important to us. 🧐Therefore, we constantly strive to ensure that
Product news November 2021
In November, we introduced 23 new products to our offer, including parts for cars: Honda, Land Rover, Mercedes, BMW, Fiat
Center support bearings – the second part of the novelties, October 2021
Another part of the new centre support bearings, which appeared in our offer in October. The previous batch of novelties
Center support bearings for BMW and Mercedes — New products – October, 2021
October is marked by rubber elements for the Propshaft – this is what our list of the new products for
Lancia Thesis
Lancia Thesis is a car that is impossible to pass by indifferently, either admired or viewed with unusual interest. All
New products – September 2021
Driveshaft supports are important elements of the drive transmission in cars. They keep the propshaft in the correct alignment while
Manual for the puller TED97715 (Manual #40)
Bushings puller TED97715 for the bushing 00503549 in Opel Astra H and Opel Zafira B. The puller allows the correct
Removal of metal-rubber-metal bushing and installation of non-glued metal-PU or metal-rubber bushing (Manual #16)
How to correctly replace 3-parts bushings? Before replacing Removal process 1 Remove the inner sleeve with the rubber, leaving the
New products – August 2021
Lancia Thesis is an original car for which we have produced components for the multi-link suspension of this model so
Correct way to install metal-polyurethane bushings (with 2 flanges) (Manual #15)
Very often, in the case of polyurethane bushings, there are 2 polyurethane parts with flanges, inside which a metal sleeve needs to be pressed.
