Replacing the front rear trailing arm bushing (Ford Mondeo MK4) using the TED87395 puller

The puller thanks to special fittings enables correct assembly and disassembly of two types of sleeves. To facilitate operation and ensure correct operation, grease the screw thread and the bearing. Grease is included in the kit.

Below is the exact replacement process for TEDGUM 00225980/00225984 bushing in Ford Mondeo MK4:

1

To press the bushing out, put the thrust plate that will hold the puller.

2

Apply bushing puller and drive plate for pressing the bushing out from the socket.

3

During pressing in it is important to check if the drive plate correctly goes into the socket.

4

Before pressing the new bushing in, it is important to clean and lubricate the socket. Tyre montage paste can be used.

5

Screw on the limiter to the drive plate and place lubricated bushing inside.

6

The bushing needs to be correctly placed in the socket according to the marker on the trailing arm. Next, place the puller with thrust plate and tighten the bolt.

7

While pressing in, control if the bushing goes correctly into the socket. Press the bushing in till the limiter touches the trailing arm.

8

Correctly pressed in bushing.

The puller can be also applied for:
Ford: Focus MK1, MK2, Kuga, Galaxy (05-11), S-max (02-11), C-max
Mazda: 3 (03-05)
Volvo: XC70 II, V70 III, XC60, S60 II, S80 II, V60, C30, S40 II, V50

Manual shown above is just a presentation showing how the repair procedure can be made. TEDGUM® company does not bear responsibility for any errors in the manual and incorrect interpretation of the manual. Repair should be proceded by skilled personel with the use of appriopriate tools and with keeping all the safety means. All rights reserved.

Share on facebook
Share on twitter
Share on linkedin
Share on email
Share on print

More in this category

Do you want to be informed? Subscribe to our newsletter !