Replacement of rear swingarm ball joint bushing in 5 Series, 6 Series, 7 Series and X5 BMW with the TED98203 puller

The puller enables correct assembly and disassembly of the bushing directly on the car. Thanks to the use of a triangle thread, the puller has a high durability. To ensure proper operation, lubricate the bolt and bearings.

Below is the instruction manual for the puller:

1

Before disassembly of the worn bushing, the protection should be removed, then put on the drive plates.

2

Turn the whole thing together, check if the bushing goes through the socket correctly during disassembly.

3

Remove the worn bushing and thoroughly clean the socket.

4

Lubricate the socket before mounting.

5

Set a new bushing in the socket.

6

Put on the drive plates and tighten everything together.

7

During assembly, monitor whether the bushing fits correctly in the socket.

8

Correctly pressed in bushing.

Manual shown above is just a presentation showing how the repair procedure can be made. TEDGUM® company does not bear responsibility for any errors in the manual and incorrect interpretation of the manual. Repair should be proceded by skilled personel with the use of appriopriate tools and with keeping all the safety means. All rights reserved.

Share on facebook
Share on twitter
Share on linkedin
Share on email
Share on print

More in this category

Do you want to be informed? Subscribe to our newsletter !